Our rodent control experts have the training and tools to clean and decontaminate your attic to ensure that all rodent traces are removed.
An attic cleaning service is done prior to a TAP installation.
Our attic cleaning service requires two days to complete on average. Homeowners are told it’s their responsibility to remove any items in their attic prior to our arrival.
On the first day our technicians begin by first removing any soiled insulation (whether it is blown in or rolled in) using a special vacuum / hose assembly. They will bag and haul the soiled insulation to the trash. This entire process can take several hours depending on the attic size and degree of difficulty to access the attic. For example, small attics may require our techs to crawl on their hands and knees the entire time whereas large attics allow them to stand up and move around freely.
After the soiled attic insulation has been removed, our technicians will then begin the process of vacuuming up all the rodent feces and droppings. To kill all traces of bacteria, fungus, germs, odors and mildew, they use a biodegradable disinfectant called Steri-Fab® using a sprayer. It dries in 15-20 minutes leaves no residue or active ingredients. Plus, Steri-Fab® is fragrance and dye free.
On the second day our technicians return to a clean attic to blow in the new attic insulation, such as TAP installation.
Most homeowners In Alameda need to displace loft insulating material to be able to put in insulation. There are several reasons insulation might need to be replaced. It can be outdated and inducing high power bills, it could possibly be contaminated by rodents, or covered with dirt and debris. No matter the reason is we have the equipment and expertise to remove it!
Attic Insulation Removal In Alameda Do It All:
If your loft has”blown” insulation, we use a high-powered vacuum system made specifically for your removal process; 150 foot hose is connected to the vacuum which is placed out your house and large-volume filter bags are used to collect the insulating material. This practice isn’t just efficient, but also keeps the home from being further contaminated by the insulating material being taken off your attic or crawlspace.
This form of insulation is only rolled up and put into large volume contractor bags. Removing this kind of is easier than removing the insulation mentioned above.
Once the insulation was fully eliminated and we’ve decontaminated, disinfected, and de-odorized the full loft we are now prepared to put in new insulation, wash the air ducts, and substitute the air filters. We always use R30 insulation in attics, following the recommendations of the Environmental Protection Agency (EPA).
Should you have a flea problem we have the opportunity to find their entrypoints. Once each entrance point was ascertained, we make certain that it’s perhaps not simply sealed properly, but also”rat/rodent proofed”. Our highly trained team members will obstruct entrance issues with the proper materials to make sure you will not need to take care of a rodent problem again.
After removing the old insulation installing new, cleaning air ducts, and replacing the air filters you will make certain to possess a clean attic that is secure and energy efficient to you and your family members.
Give us a call today for the Free Expert Evaluation!